Help

Principal stresses, maximum shear and the stress on any rotated plane of a plane stress state, with the circle and the element drawn.

Conventions

Tension positive, compression negative. θ is measured counterclockwise from x.

Enter the stress components at a point: σx and σy are normal stresses and τxy is the shear on the x face in the y direction.

θ turns the axes counterclockwise from x. The rotated stresses act on the faces of the element turned by θ.

On the circle, X is (σx, τxy) and Y is (σy, −τxy). Turning the element by θ moves X′ and Y′ by 2θ around the center.

θ1 goes from x to the direction of σ1, and σ2 acts at θ1 + 90°. τmax is the radius of the circle.

With τ positive upward, points on the circle turn in the opposite sense to the element. With τ positive downward they turn in the same sense, by 2θ.

Stresses are kept in MPa. Changing the unit converts every field, result and axis; the drawing stays the same.

Open in Stabileo ↗

Stress at the point

Element turned θ = 0.0°
σx′80.00
σy′20.00
τx′y′30.00

Drag X′ along the circle or turn the element by its handle; tap σ₁, σ₂ or τmax to go to that plane. In a field, the arrow keys, the wheel or dragging its label change the value.

σ1 major
92.43 MPa
σ2 minor
7.57 MPa
τmax maximum shear
42.43 MPa
θp from x to σ₁
22.50° θ2 = 112.50°

Mohr circle

?

With τ positive upward, points on the circle turn in the opposite sense to the element. With τ positive downward they turn in the same sense, by 2θ.

050100-40-2002040σ [MPa]τ [MPa] +↑τmax42.43σ₁ 92.43σ₂ 7.57XY

Element at θ

σ₁σ₂80.0020.0030.00Turn the element: drag it or use the arrow keys
  • Tension
  • Compression
  • Shear
  • Current plane
  • Principal directions

3D stress state and Mohr circles →