Free structural engineering tools

3D stress state and Mohr circles

Help

Principal stresses and directions of a 3D stress tensor, and the traction on any plane you cut: drawn on the element, on the sphere of all planes and on Mohr’s three circles.

Conventions

Tension positive, compression negative. θ is measured counterclockwise from x.

Enter the six independent components of the symmetric tensor; the lower triangle, marked sym., repeats the upper one.

The plane is given by its unit normal n, from the azimuth φ measured from x in the xy plane and the polar angle θ measured from z.

The traction on that plane is t = σ·n. Its component along n is σn and the remainder, in the plane, is τn.

Every pair (σn, τn) lies between the three circles built on σ1 ≥ σ2 ≥ σ3. τmax = (σ1 − σ3)/2.

φ turns around z from x; θ tilts down from z.

Octahedral: the plane equally inclined to the three principal directions, where σn is the mean stress and τn the octahedral shear.

Stresses are kept in MPa. Changing the unit converts every field, result and axis; the drawing stays the same.

Open in Stabileo ↗

Stress at the point

sym.

Cutting plane

n (0.883; -0.321; 0.342)
σn34.57
τn57.68
σ1 major
92.53 MPa
(0.926; 0.377; -0.029)
σ2 intermediate
14.57 MPa
(0.341; -0.865; -0.368)
σ3 minor
-37.10 MPa
(0.164; -0.330; 0.929)
τmax maximum shear
64.81 MPa
σVM equivalent
113.03 MPa
σm = 23.33

Traction on every plane

?

Tap the sphere to cut along that plane, or tap σ₁, σ₂, σ₃ or τmax on the circles. Drag the sphere or the cube to turn the view.

Drawing options

xyzσ₁σ₂σ₃nt-92.592.5σn on each plane [MPa]

The plane on the element

nσnτntxyz

Mohr’s three circles

-1000100050σn [MPa]τn [MPa]τmax64.81σ₁ = 92.53σ₂ = 14.57σ₃ = -37.10n (34.57; 57.68)
  • Tension
  • Compression
  • Shear
  • Current plane
  • Principal directions

Mohr circle 2D →